User's Manual

2
2
8. Remote temperature-controlled start on/off [Refer to Remote Transmitter’s Features]
This feature enables engine start automatically when the pre-set temperature is reached. The engine running
will stop when the pre-set runtime expires. [refer to Features Program Table at 31 ]
9. Programmed daily start time on/off [ refer to Features Program Table, at # 32]
Daily start time can be programmed. Decide and set daily start time exactly at the desired time of the day .Once
this feature is “ ON ” ; from the next day, your car will auto engine start at pre-set time daily.
10. Trunk release ( activate channel # 1 )
To release trunk regardless of the car’s lock or unlock status, press and hold button 【 】 . The parking light
flashes twice to confirm trunk release。
The remote transmitter sounds melody , LED lights up to show car status
11. Headlight delay ( activate channel # 2) [refer to Features Program Table ,at # 31 ]
To have head delay, press buttons and simultaneously either in arm or disarm modes. Following 2
parking light flashes, headlight stays on 30 sec before it automatically turns off.
The remote transmitter sounds melody and LED lights up to show car status
12. Defective zones alert upon remote start
Remote engine start fails if there is a defective zone like the trunk being released or handbrake un-engaged
The remote transmitter reflects with 4 buzzer sounds and its LED lights up to show car status.
13. Status Check
Press button【 】to monitor the latest vehicle status. The parking light flashes 3 times.
The remote transmitter sounds melody and its LED lights up to show vehicle’s status.
14. Remote valet mode [ refer to Features Program Table 1 at # 31 or Remote Transmitter’s Features]
Press button , and to switch valet mode “ON” ; car’s parking light flashes 4 times, its siren
chirps 4 times; the remote transmitter reflects with 3 buzzer sounds with its upper- and middle-LED blinking a
while . Under valet mode ”ON” , the remote engine start is not operative while other features are still operative.
All features become operative when the valet mode is turned “OFF”.
To switch valet mode “OFF” , press and hold all , and simultaneously for a few sec, siren chirps 3
times;
The remote transmitter reflects with 3 buzzer sounds with all LED blinking a while.
15. Remote siren ( horn ) on/off [ refer to Features Programmed Table at #30 or Remote Transmitter’s
Features ]
Different programming can set the siren’s ( horn’s ) sound loud / soft or mute as desired.
16. Status feedback & confirmation signal [Refer to Remote Transmitter’s Features ]
Having received transmitter’s command and successfully processed its command, the main system will sends
feedback signal to the transmitter which will then reflect with confirmation signal or latest status reports by its
buzzer sound and/ or LED lights.
FEATURES OF MAIN UNIT
17. System’s code-learning from 4 different transmitters[Refer to Code Learning at #29]
The main unit can learn coding from 4 remote transmitters.
18. Power failure memory
The main unit retains the memory of last settings if its power source is disrupted.
19. Low voltage auto engine-rest
The main unit will terminate engine running if its power voltage becomes low at 5 v.
20. Safety remote engine start/stop engine circuit
For each time of remote engine start, the main unit will perform check on related circuit .Only in perfect
condition of all switches , will the engine start.
21. Smart of engine crank circuit
Having received remote engine start signal by remote transmitter, the system will try engine starting. Cranking
will automatically terminate immediately after engine-start success.
22. Success of engine start diagnosed RPM/voltage [ Refer to the Installation Diagram, note (9) ]
The main unit will diagnose the engine-start success be means of RPM or voltage sensing.