User's Manual
1
1
MODEL TR68A USER’S MANUAL
※
PRE-INSTALLATION CHECK
1. For safety sake, check first if your ignition key can activate engine start while the hand gear is engaged. If
engine starting is possible while hand gear is engaged , the gear mode must be in “manual hand gear mode”
during installation ( Refer to the operation guide ) .
2. Check if immobilization feature is present in your auto mobile [A1].If so, another accessory ( Item no: 444 )is
required to enable remote engine start and this is buyable from the same dealer.
3. Check the circuits and their current first. Refer to [ Installation diagram for input / output current values]. If
the output current is lower than requirement, additional relays must be added.]
※
Check the followings after installation of alarm system
1. Installation is abnormal if the remote engine start can be done under these conditions (a) the gear is engaged
(b) ignition key is in “Ignition On Mode” (c) the engine hood is open ( d) the hand brake is not engaged.
2. The remote control should enable operation of functions in the same way as the original ignition key. If
remote control can hardly remote engine start, the installation abnormal. Check the related circuit connection
of the ignition cylinder.
3. For servicing , repair and valet parking, “ Valet Mode “ must be set to “ON”
REMOTE CONTROL FEATURES
1. Remote door lock
To lock door , press button【 】, siren chirps once and parking light flashes once.
Middle button of the remote transmitter lights up with 1 buzzer sound.[ If remote’s buzzer makes 4 sounds,
system is not working normally.]
2. Remote door unlock
To remote unlock the locked vehicle, press button【 】, siren chirps twice and parking light flashes twice.
Upper LED lights up with 2 buzzer sounds.
3. Two steps door unlock or Channel # 3 [ Refer o Features Programmed Table , at # 32]
Another accessory buyable from the same dealer is required to have this feature. A press on button【 】can
unlock driver’s door and longer press on the same button can unlock all other doors. Siren chirps 3 times and
parking light flashes 3 times.
The remote Upper LCD lights up with 3 buzzer sounds.
4. Car locator / search
To locate the car, press button
【
】, siren chirps 6 times with 6 parking light flashes.
The remote LED indicates car’s status with melody
5. Remote engine start
To remote engine start, press and hold this button【 】; siren chirps 3 times with 3 parking light flashes.
The remote lower-LED lights up with melody upon engine start success ( LED blinks differently depending
on car’s status of unlock/lock ).
For runtime setup, refer to Program Table at # 30. Engine run stops when preset time expires.
6. Remote activate engine run time
Following the success of engine start, press engine run time button to automatically add up engine runtime with
5 min stepup for each button press .Maximum 20 min runtime can be attained . Engine stops automatically
when the runtime expires. [Refer to Remote Transmitter’s Features]
7. Remote engine stop
To remote stop engine run (excluding engine run by ignition key) , press and hold the button【 】 .Car engine
stops with 2 confirming siren chirps & 2 parking light flashes.
The remote lower-LED sounds melody , the lower-LED does not light up .(The rest LED may light up
depending on lock / unlock status)