User's Manual
(c)、The remote start run time can be programmed as required [RF program table]. When the preset run time expires, the engine
will automatically shut off.[ The remote unit displays 『r 01』 when the last one min begins its countdown ]. The 『r 00』
displays on the remote unit at the moment of engine shut-off and then disappears.
(d)、Remote engine start cannot be done under such abnormal conditions. (1).The gear is not in its neutral position, (2) Ignition
key is turned ON , (3) Hood is opened ,(4) Hand break is depressed .Only under normal condition, the system can be
remote-started for the pre-set runtime. A maximum of 4 start efforts will be made in case of failure of engine-start in the
preceding trials. If engine gets started in any stage of trials , no second attempt will be made.
l When the system fails engine start after the 4
th
unsuccessful start effort, the remote unit sounds 4 beeps and its LCD
displays 『SP』 .
5.
Remote change of engine run time
(a)、After the engine gets started by the remote unit
(b) 、Press Ⅲ button quickly twice or more the to pop up the cursor and more the cursor onto the 【 】column.
(c) 、Press and release 【Ⅱ】button. Each time press on this button can add up 5 min run time and additional pressing can get
up to the maximum run time of 20 min. The LCD on the remote unit displays the current run time acquired. The 『r 15』on
the LCD means the current run time you have gained is 15 min.
Note:The function of run time change is only accessible only when the engine is running.
6. Remote engine shu toff
(a)、The engine is running by remote unit.
(b)、Press and hold 【Ⅰ】; the engine shuts off with 2 siren chirps and 2 parking light flashes.
l The 『 』disappears from the remote unit’s screen .The car’s status is displayed on the remote unit and melody is
heard .