User's Manual

Remote control channel # 3 【RF program table 】
(a)、If the system is programmed for channel #3 mode ( an external accessory is required )
(b)、Press quickly 【Ⅲ】twice or more times to pop up cursor and then move it onto
【 】 ).
(c)、 Then press and release【Ⅱ】.The system responses in accordance with selected
function mode .The parking light flashes 3 times for confirmation.
l The remote unit displays Car Status on its screen and sounds 3 beeps Single
Option
( Choose
only
one of
these)
2 stage door unlock , disarm 【RF program table 】
(a)、If the system is programmed channel # 3 for 2 stage door unlock mode. ( an external
accessory is required)
(b)、 Press quickly【Ⅲ】twice or more times to pop up the cursor and then move it onto
【 】)
(c)、Then press and release 【Ⅱ】to unlock all the doors. The system will unlock and
disarm with 2 siren chirps and 2 parking light flashes.
l The remote unit displays 『 』on its screen and sound 2 beeps.
※ Choose one of the above two options and program it as required.
4. Remote engine start (Refer to item 23 for manual transmission gear mode )
(a)、The engine is in shut off state.
(b)、Press and hold 【Ⅰ】 button . Or press Ⅱ button when the active cursor is shifted onto the 【 】the column. Siren
chirps 3 times with 3 parking light flashes when the engine gets started.
l The remote unit displays 2 stages on its screen as below：
(1)、In the 1
st
stage: The remote unit displays the current status along with 『 』while engine is trying for engine start
and sounds .
(2)、In the 2
nd
stage: After the engine gets started , the remote unit displays 『 』 along with engine’s preset run time
and sounds .