User's Manual

Self-defined functions by a short press of button 【Ⅱ】
Press and release button【Ⅱ】to activate self-defined function .It is generally programmed to assign for Mute Arm Mode.
other functions can also be programmed as below
Step 1
Press buttonⅢ】twice or more times quickly to pop up the cursor. Move the cursor to the desired position by pressing
button【Ⅲ】a number times as necessary . For example, move the cursor on to , if you want to have Status Check
function activated by a short press of button【Ⅱ】.
The following 2 way remote
s function guide is based on the current cursor setting in the above passage
1. Remote arm & door lock
(a)Shut off the engine, get off the car making sure handbrake is depressed, hood closed and all the door closed.
(b)Press and release button【Ⅰ】 the system will lock the door and enter arm mode with 1 siren chirp and 1 parking light flash.
l The remote unit sounds melody and displays 』『 icons on its screen.
(c)Press and release button【Ⅱ】 the system will lock the door and enter arm mode with 1 siren chirp and 1 parking light flash.
l The remote unit sounds melody and displays icons on its screen which means the system is in mute arm
mode.
(e)Defective zone report and bypass arming:
When arming, if the system detects defective zones, the system will sound 4 siren
chirps or the remote unit sounds 4 beeps twice. The remote unit displays on its screen the defective zone ( like the door
unclosed yet).The system then will bypass the defective zone and can enter arm mode. When the defective zone is
corrected ( just by closing the door later ), the system immediately enters full arm mode.
(g) Arm delay time can be programmed
( like 6 or 30 sec daily arming after door is closed) as needed.RF program table