User's Manual

Manual Disarm Mode
(a) Turn the ignition key to ON position. (But engine must not be running)
(b) Press and release the over-ride switch 4 times
(c) Turn the ignition key to OFF position {siren chirps 2 times with 2 flashes of parking light}. The system will enter Disarm
mode.
Note(a)Under manual Arm mode; if the system is triggered, the system will enter initial alert mode ( siren chirps 3 times with 3
parking light flashes). 20 sec later , the system enters Alarm and Warn Away Mode. [The alert triggering at this stage
can be terminated by the car owner]
(b)Under manual Arm or Disarm modes, all the systems features can still be operated by the remote unit.
23. Procedures of remote start for manual transmission gear
(1)While engine is running by ignition key, pull up the hand brake.
(2)Press and release 【Ⅰ】and try to complete steps (c) and (d) within 30 sec.
(3)Turn the ignition OFF while the engine is still running.( Engine is running at this stage)
(4)Open the car door, get off and re-close the door ( Engine will automatically shut off at this stage).The engine start is
operable remotely afterwards. If there is any mistake in the procedures, the engine start by remote unit is disabled.
NoteFor safety purpose each time when remote engine-start on the manual transmission car is desired, definitely follow the
above procedures.
24. Procedures for Code learning of remote units
The L-TR53B main system can memorize transmitters coding ( from up to 4 different remote units)
(1) Turn the ignition key to ON (But engine must not be running)
Press and hold the over-ride switch for 6 sec and release it after the siren chirps 4 times which confirms the system has
entered active learning mode.
(2) Press and hold+Ⅱ】simultaneously till the siren chirps 1 time ,confirming code learning is completed.
Follow the same step (2) with other remote transmitters ,one after another, to allow the main system learn coding of each
transmitter.( Maximum 4 remotes can be learned by the L-TR53B) .The system will automatically jump out of learning
mode if no signal is received within 6 sec. from the last signal.
(a)The pre-memorized coding will be erased each time the learning mode is activated.
Re-do the code learning in this case.
(b) If more than one remotes are used in remote-operating the same system, the car status will be displayed on the single
remote which sends the latest signal.