User's Manual

Active channel # 3 [RF features programmable ]
(a)、If the main system is set at channel # 3 mode {additional accessory is required}。
(b)、Press and hold【 】： The parking light flashes 3 times [system responses according to
programmed mode]。
l The remote LCD shows up current car’ s status with 3 short beeps.
Single
Option
(choose
one
only)
2 Steps door unlock /disarm [RF features programmable ]
(a)、If the system is set at 2 Steps door unlock mode {additional accessory is required}。
(b)、Press and release 【 】： the driver’ s door is opened。
(c)、Press and hold 【 】：
all the car’ s doors are unlocked and the main system disarm itself at the
same time. Siren chirp 2 times with 2 parking light flashes.
l The remote LCD shows『 』 icon with 2 short beeps。
Note: Choose one of these options as required for your programming.[ Refer to RF features
programmable]。
4. Remote engine start [Refer to item 24 for manual transmission gear mode and RF features
programmable ]
(a)、While the engine is shut off。
(b)、Press and release【 】Siren chirps 3 times with 3 parking light flashes when the engine is started。
l The remote LCD responses as below ：
(c)、 During the 1
st
stage: The remote LCD shows up the current status along with 『 』during the pre-starting
stage and the melody sound：
(d)、During the 2
nd
stage: When the engine is started , the remote LCD shows up 『 』icons along with engine’ s
preset run time and s melody sound.
Note ：
(e)、The remote start run time can be programmed as required.[RF features programmable] When the preset run
time expires the engine will automatically shut down.[ The remote LCD will show 『r 01』 when the last
remaining 1 min begins ]。The remote LCD shows 『r 00』 at the moment of engine shut-off and
disappears.
(f)、Remote engine start cannot be done under such abnormal conditions. (1).The gear is not in its neutral
position (2) Ignition key is turned on (3) Hood is opened (4) Hand break is depressed .Under such normal
condition, the system will start with the pre-set runtime. Additional 3 times of starting will be done in case
of the 1
st
start failure. If starting succeeds, there will be no second attempt.
(g)、When arriving your vehicle, press and release remote unit’ s button【 】enter the vehicle and turn the
ignition to “ON” position.
6