User's Manual

23. Procedures of remote start for manual transmission gear car
(a)、Auto transmission gear car : To enable remote engine start, the gear shift must be in the neutral mode
Otherwise remote engine start is disabled.
(b)、Procedures for Manual transmission gear car :[ The system must be in the manual gear mode]。
(1)、While engine is running by ignition key, pull up the hand brake.
(2)、Press and release【 】and try to complete steps (c) and (d) within 30 sec.
(3)、Turn the ignition off while the engine is still running.( Engine is running at this stage)
(4)、Open the car door, get off and re-close the door ( Engine will automatically shut off at this stage).The
system’ s start is operable afterwards. If there is any mistake in the procedures, the system’ s engine start is
disabled.
Note：To operate our system safely; each time remote engine starting of the manual transmission car. definitely
follow the above procedures to enable remote starting.
24. How to learn codes of the remote transmitter
The LEA-825 main system can memorize transmitter’ s coding ( from up to 4 different remote units)
(1) Turn the ignition key to “ON” ( Engine must not be running)
Press and hold the over-ride switch for 6 sec and release it after the siren chirps 4 times which confirms the
system has entered active learning mode.
(2) Press and hold 【 + 】simultaneously till the siren chirps 1 time confirming code learning is completed.
Follow the same step (2) with other remote transmitters ,one after another, to allow the main system learn
coding of each transmitter.( Maximum 4 remotes can be learned by the LEA-825) .The system will
automatically jump out of learning mode if no signal is received within 6 sec. from the last signal.
Note：
(a)、The pre-memorized coding will be erased each time the learning mode is activated. Re-do the code learning
in this case.
(b)、If more than one remotes are used in remote operating the same system, the car status will be displayed on
the single remote which sends the latest remote signal.
25. Dash LED status indicator
Fix the LED status indicator at the appropriate location inside the car to allow maximum visibility of it.
LED blinking pattern for various standby modes while ignition key is turned “ OFF ”
Different standby modes Pattern of LED blinking
The remote engine being started L E D solid on
Alarm mode being cleared No L E D light
Arm mode * * * * * * * *
Daily auto-start time ON ** ** ** ** ** ** **
Temp -controlled auto-start ON *** *** *** *** ***
Daily auto-start time ON + Temp - auto-start ON **** **** **** ****
Valet mode ON ***** ***** ***** *****
12