TABLE OF CONTENTS Users’ Precaution The remote LCD icons with functions ..................................................................................3 Door Lock/arm............................................................................................................................5 Defective zone bypass..................................................................................................................5 Door unlock/disarm..............................................................
LEA-845 2-WAY REMOTE CONTROL QUICK OPERATION GUIDE 1. LEA-825 has 5 buttons which are described in this guide as K1, K2 ,etc.. as shown in the bracket :【K1 = 】、【K2 = 】、【K3 = 】、【K4 = 】。 2. The S、L marked behind each bracket show pressing mode. S requires Press and release of the button , L requires Press and hold of the button 3. Following each press on any button ; if 『 』disappears from the LCD, the remote unit is out of range from the vehicle or the transmission is being blocked out by other interferences.
Functions & icons of LEA-845 2 way remote unit 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Alarm clock mode Count-down timer mode Page-out transmitting AM time mode PM time mode Un-lodged hand brake indication Daily auto-start time mode Temp -controlled auto-start mode Hour, minute indication Car’ s interior temp Celsius / Fahrenheit mode Power save mode of remote(Absolute current sleep mode of the remote, after system is disarmed) 13. Vibration alert mode 14. Ignition On mod e 15. Valet mode e 16.
LEA-845 SUPER RANGE 2 –WAY SECURITY WITH REMOTE ENGINE START USER’ S MANUAL ※ USERS’ PRECAUTION 1. To fully utilize whole system’ s features with ease , read the installation manual thoroughly。 2. Be sure to remote start your car only parked outside to avoid being suffocated by engine’ s emission as in situation of parking inside in the garage。 3. Valet mode must be turned ON for servicing or maintenance of car。 4.
1. Door Lock/arm (a)、Shut the engine down, close all car doors assuring all hood and trunk are closed and handbrake is pulled up。 (b)、Press and release 【 】;siren chirps once with 1 flash , the car door is locked and system enters arm mode。 l The remote unit has the following responses.
Active channel # 3 [RF features programmable ] (a)、If the main system is set at channel # 3 mode {additional accessory is required}。 (b)、Press and hold【 】 ：The parking light flashes 3 times [system responses according to Single programmed mode]。 Option l The remote LCD shows up current car’ s status with 3 short beeps.
5. Remote control run time with status check (a)、Following the success of engine start; press both【 + 】simultaneously each time to allow 5 min engine run time with maximum up to of 20 min. The remote LCD shows up t he runtime achieved. For example the LCD’ s icon that shows『r 15』means engine run time is 15 min。 (b)、 Following the success of engine start; press and hold both 【 + 】simultaneously to check the remaining engine run time.
8. Daily auto-start time ON/OFF (a)、Daily auto-start time ON: Press and hold both 【 + 】simultaneously，the engine will auto-start at the real time of entry beginning from the next day. Siren chirps 6 times with 6 flashes of parking light and immediate engine running. (b)、Daily auto-start time OFF: Press and release both 【 + 】simultaneously to turn this function OFF. l The remote LCD responses as below: (c)、Dairy auto-start time ON : The remote LCD shows both『 』and sounds melody if this mode is chosen.
12. Active channel # 2 (for use to turn on headlight for example ) (a)、This function can be remote controlled even the main system is arm or disarm modes. ( an additional accessory is required and can be programmed for the desired function ). For example: the 30 sec headlight ON. (b)、Press and release【 】 ： The parking light flashes 2 times and headlight turns on for 30 sec before automatically turns itself off. l The remote LCD shows up the car’ s current status and sounds melody.
16. Remote Panic (a)、When the engine shuts off; press and releaser both 【 + 】simultaneously，the parking light flashes 3 times and siren chirps 3 times. l The remote LCD shows up current car’ s status and sounds melody. 17. Remote anti-carjack ON (a)、Press and hold both【 + 】simultaneously to activate this function . Parking light flashes and siren blurts for 30 sec. The engine start circuit is killed immediately till this function is deactivated. (b)、Press and release【 】to deactivate this function.
21. Programmable function by over-ride switch (a)、The LEA-825 model’ s functions 【valet, daily auto-start time ,temperature-controlled auto start 】can be switched into ON/OFF modes using over-ride switch in the following procedure. (1)、Turn the ignition OFF (2)、Press and release the over-ride switch for assigned number of times to enter various modes [ 3 times to enter valet change mode ]，[ 4 times to ent er daily auto-start time ]，[5 times to enter temperature-controlled auto start].
23. Procedures of remote start for manual transmission gear car (a)、Auto transmission gear car : To enable remote engine start, the gear shift must be in the neutral mode Otherwise remote engine start is disabled. (b)、Procedures for Manual transmission gear car :[ The system must be in the manual gear mode]。 (1)、While engine is running by ignition key, pull up the hand brake. (2)、Press and release【 】and try to complete steps (c) and (d) within 30 sec.
26. Programming of remote control unit The LEA-825’ s LCD remote control unit has basic features of (a) EL backlight (b) most power saving circuitry (c) audio or vibration alert mode (d) different time indication of【Real time, alarm clock, count -down timer 】.
Caution: Any changes or modifications mot expressly approved by the party responsible for compliance could void the user's authority to operate the equipments.
