User's Manual

G. Throttle Trigger
- Use the throttle trigger to control the throttle and braking for your model.
- Pull the trigger for throttle and push it for braking or reverse. (some of the ESCs support the
Reversing function)
H. Steering Trim
- Before you use the steering trim, you should center servo horn closer to the neutral position
with the linkage, and then use the trim to fine-tune the steering.
- Adjust the steering trim to make your model running perfectly straight when the steering
wheel is centered.
I. Throttle Trim
- Use the throttle trim to adjust the braking power; this is the amount of braking that occurs
when you let go of the trigger. Be aware that too much brake may affect the servo end point
preventing maximum power.
- When using a electronic speed control, you should keep the throttle trim in the center
position.
- Do not mount the horn on the servo until you turn on the radio and center the trims.
J. Steering Dual Rate
- Use the D/R function to adjust the overall travel of the steering servo.
- Push the D/R forward with your thumb for maximum steering and pull back for the minimum
steering.
K. Charger Jack
- When you use the rechargeable batteries (ex. Ni-Cad battery), you can insert the connector of
the charger into the jack to charge the batteries.
L. Battery Cover
- Remove the battery cover to change the batteries.
M. Crystal
- Replace the crystal to change the radio frequency.
- Do not use other brand’s crystal or the transmitter won’t work properly.
N. 2 / 3 Channel mode Switch
- Use this switch to change the transmitter to 2 or 3 Channel function.
- When the mode switch set in 2 channel mode, the multi-function switch will be set in “Dual
Rate Override” trigger.
- Or the mode switch set in 3 channel mode, the multi-function switch will be set in “3
rd
channel” trigger.
- About the detail operations, please refer the “Multi-function Switch” section.
- Note: When you switch the 2/3 channel mode switch, please turn the transmitter power
off first, or the setting won’t be set in. After the switch settle down, and then turn the
transmitter power on.
O. Multi-function Switch
- According to 2/3 mode switch setting, the multi-function will be set in two different function.
 2 Channel mode (Dual Rate Override)
Trigger off this function, the D/R value will be set in 120%. After shutting off, the D/R
value will become to the original setting.
 3 Channel mode (3
rd
channel switch)
- Before use this function, you should plug the 3
rd
servo into receiver to enable the 3
rd
channel function with your model.
- Trigger this switch on, the 3
rd
channel servo will swing from original position to another
side.
- According to mechanical design of the model, you may switch the 3
rd
channel trigger
from on to off for reversing the servo direction.
P. Neck strap Hook