User's Manual

10. Reference
A. Troubleshooting
If your R/C system works abnormally, ex: remote range is short, transmitter malfunction, etc, please
check the table below to take the action to solve the problem, if it couldn’t solve the problem, and then
please contact your dealer to get the service.
Problem Check point Action
Batteries low Replace the batteries. Charge the
Ni-Cad batteries.
Crystal wrong, damage or
disconnected.
Please use the correct band crystal for
both transmitter and receiver. Check the
crystal connection; reinsert it into the
crystal holder tightly.
Remote range is short
Antenna disconnected.
Not extended to full length.
Screw it to the end.
Extend the antenna fully.
Servo is not running
smoothly
Receiver batteries low
Linkage binding or looseness
Replace the batteries.
Check and adjust the model.
Operation stops
intermittently
Wire disconnected. Reinsert the connectors.
Push it tightly.
Model is glitch or
servo is running
erratically
There is another radio
operating on you channel.
The receiver antenna is near
the power wire.
Replace the crystal band.
Keep the antenna away from the power
wire.
B. User Tips
- Adjust the dual rate appropriately, it will make your
model passing the corner perfectly.
- Adjust the servo horn position and linkage so both are
parallel, it will make the servo action efficiency.
- Control your steering and throttle Nimbly, don’t push
the speed too much and overshoot when pass the
corner.
- Be careful to drive your model to prevent the crash.
Practice more on the conservative track to be familiar
with the operation, and then try the advance track.
- Have fun with your LG2-01!
警語:
根據交通部 低功率電波輻性電機管理辦法 規定：
第十四條 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率
或變更原設計之特性及功能。
第十七條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改
善至無干擾時方得繼續使用。
前項合法通信，指依電信規定作業之無線電信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射
性電機設備之干擾。