CONTENTS Precautions Attachment / detachment of belt clip Installing / Replacement of batteries Icons VS their functions Buttons VS function operations (1)Power button (3)Down / Up buttons (4)Monitor button / +/ backlog t function (5)Function button | s selection (b)Vox on / off choice .
Puy Precautions « (1) Do not change/modify the starstruck or replace corespondents which may result in illegal usage of such device afterwards (2) Avoid using this device onboard airplane , at highly sensitive radio-triggered mining facilities or whore prohibition notice against use of such device is given . (3) Take out thc batteries if not in use for month-long period to avoid battery leakage. (4) Avoid storing in extreme temperatures or highly Minim environment.
Note: The belt clip can easily be taken ofl if desired before replacement of batteries . b) Install or replace standard battery pack or 3 AA batteries according to battery pole direction which i¢ clearly marked inside the battery compartment.
Displays creature chance! number ( 1.
Buttons VS Function operations « button: Press and hold red button to tum cn. Press and bold same bunion to turn off. ( PTT ): Press PTT while talking to microphone (front perforated panel) to transmit voice to target receiver. Press a fow sec before talking and keep about 5 cm from speaker to attain best result Release it immediately slier talking, (3)Down bunions: Combined with F button, these are used {o select different setting during any active function modes.
(a) Channel selection: Press F 1 dime to activate channel setting mode. Press up 2 or down ¥ button momentarily to select channel Same channel setting is a must to telecommunication with one another. (b) Tone call selection: Press F 2 times to activate tone call siting mode. Pres sup 2 or down VV to Choose beep tone C1~C 7. [BF | How to operate: Press and hold PTT then press C ie send a tone call to target transceiver. Purpose: 7 different tones may convey various ideas to one another.
report. Purpose: This helps one check if the target transceiver is within effective range or learn its surrounding status. Button Confirmation Beep on / off choice Press F button to activate this mode till if ) fishes. Pres sup £% or down +7 otiose on/off. Unction-setting mode can be finalized either by pressing PTT or C button after all function settings are completed or at any stage of active function mode, (0). CSS Codes ( Privacy codes): Press C a few seconds button to activate its mode.
(i) “Hold PTT" transmission : "Hold PTT * transmission {function eliminates the need to press PTT continuously during transmission. Press & hold PTT then press power 71 button to activate this. Icon 4Y appears through out while this function is being used. To stop it, press once on PTT. (j). Auto Power Of (APO): Press twice the power bunion while the power is “on” can attain this. The transceiver automatically tums off after 30 min. from last key entry or last incoming call.
SHORT USER GUIDE Back light {5-sec auto-off ) Function Press & hold red button to tum of, Repeat same procedure 10 turn off Press & momentarily (0 tue on Procedural Guidance Required i per-condition {Batteries properly ir While power on" unlocked state docked or | Voice monitor (To check volume fave] setting) Volume control Press & hold & o newsstands to hear volume level previously sot While power "on *, locked or Unlocked state Press up or down bunion to adjust volume Channel selection "| While power "on"
To transmit voice Cross PTT and talk to speaker at 5 om distance _{must have same CSS ) Counterpart’s receiver set on | same channel ( if receiver uses CSS number, transceiver ‘To transmit tone call While pressing PTT, press C shortly While power “on” , locked or unlocked state | To transmit with While pressing I TT ‘press power While power "on ", locked or "Hold PTT" button unlocked state ( no incoming signal can be received tll this mode is canceled , press PTT to cane! this ) To receive Release undress)
too far away Janet clews Own transceiver ie HOLY [Press momentarily PIT to monitor” {3 Icon cannot be seen No back light after monitor button is pressed In Hood PTT mode 13 PTT mode release this made Transceiver beeps while Batteries power very | Tow Charge or replace them | PTT is pressed |All display Loons blink [Batteries power ex Charge or replace them | "Remote controlled rss inactivated disclose CSS reds PTT one time fo release Hold PTT mode Backlogging goes out untimely VOX function in action Set VOX
NOTICE: This device complies with Part 95 of the FCC rules.
