Instruction manual

28
In this case, DVR can save HDD usage and network bandwidth.
If you select CBR, DVR will use the fixed bit rate to compress image.
 Frame Rate: Frame per second. Options are: 25（PAL:25, NTSC:30）、13、6、3、1. Default frame rate: “25”
 Quality: Define the image quality. There are 5 options: Basic, Medium, Good, High, and Best. High image
quality needs high bit rate size. Default quality: High
In the course of setting up the parameters, if the parameters needed to be set the same in all channels, you can
select ‘ALL’ after finishing the setup of parameters of one channel. The system will prompt a dialog box. When
pressing ‘OK’, parameters setup for all channels will be achieved.
Manual Recording
Press “●” button on the panel to enter into “Manual Record” interface directly.
图 20
 1-4 CH Status: “√” and “×” on up side stand for recording status. “√”means recording, “×”means
idle.
 1-4 CH Start/Stop recording: Squares on downside are used to start/stop recording of the
corresponding channel. Press “ ” and “ ”on the panel to select channels. Press “ ” and “ ” to
start/stop recording.
 Record: Press this button to start all channels recording.
 Stop: Press this button to stop all channel recording.
 Return: Press this button to close the Manual Record window.
Check channel recording status in the red circle of status bar as shown in the following Fig.