Service manual

15032 “Jam Out Of Collector”
HARDWARE: Collector
WHAT HAPPENED
Cycling, a pack did not leave the Collector within a time.
ACTION TO TAKE
Check for a jam at the Collector.
Test the the operation of the dump rollers at the Collector. Transfer
Conveyor Clutch(I/O 0:21)
Test the sensor at the Collector. Transfer Conveyor In Sensor(I/O 0:12)
ANY OTHER ADJUSTMENTS
Adjust Engin Value#9 XcvyN OutOf Sta time.
Adjust Engin Value#nn dump rollers at the Collectortime.
15036 “Missing Pack Sta 1 – Set Sta Empty”
HARDWARE: New Xfer Conveyor, Bridge and Two Stage
WHAT HAPPENED
At Power On, Motors On, a pack was not sensed as expected at Xfer
Station 1.
ACTION TO TAKE
Test the sensor at Station 1.
Test the clutch and brake at Station 1.
ANY OTHER ADJUSTMENTS
This pack was marked bad.
Was there an Xfer Conveyor error in the previous cycle?
Remove and inspect this pack and other suspect packs or allow the pack
to be diverted for inspection downstream.
Set Engin. Value#55 to 1 to set all packs in the Xfer Conveyor bad.
The following device, maybe an Inserter, may have provision to divert bad
packs for inspection.
15037 “Missing Pack Sta 2 – Set Sta Empty”
HARDWARE: New Xfer Conveyor, Bridge and Two Stage
WHAT HAPPENED
At Power On, Motors On, a pack was not sensed as expected at Xfer
Station 2.
ACTION TO TAKE
Test the sensor at Station 2.
Test the clutch and brake at Station 2.
ANY OTHER ADJUSTMENTS
This pack was marked bad.
Was there an Xfer Conveyor error in the previous cycle?
Remove and inspect this pack and other suspect packs or allow the pack
to be diverted for inspection downstream.
Set Engin. Value#55 to 1 to set all packs in the Xfer Conveyor bad.
The following device, maybe an Inserter, may have provision to divert
bad packs for inspection.
PROBLEM ANALYSIS
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION C – PAGE 95
071-33370-400