Service manual

ManualsBrandsWinSystems ManualsComputer equipmentSAT-520PLUS

100

Adjust Engin Value#7 Xcvy Clutch On Time to place 3 packs evenly in

the Original Xfer Conveyor.

—The last pack should be about 1 inch from the exit rollers.

If packs are pulled from the Original Xfer Conveyor data remains

because there are no sensors at Stations 2 and 3.

—Power Down, clear Accumulator and Xfer Conveyor. Power Up and

re-load Accumulator and Xfer Conveyor.

15020 “Jam Into Xfer Cnvy Station 1"

HARDWARE: Original Xfer Conveyor

15020 “Jam Into Xfer Station 1"

HARDWARE: New Xfer Conveyor, Bridge and Two Stage

WHAT HAPPENED

Cycling, a pack did not reach Xfer Station 1 within a time.

ACTION TO TAKE

Check for a jam in the Folder.

Test the sensor at Station 1.

Test the clutch and brake at the Accumulator.

ANY OTHER ADJUSTMENTS

Adjust Engin Value#8 XcvyN Into Sta time.

This pack was marked bad.

Was there an Xfer Conveyor error in the previous cycle?

Remove and inspect this pack and other suspect packs or allow the pack

to be diverted for inspection downstream.

Set Engin. Value#55 to 1 to set all packs in the Xfer Conveyor bad.

The following device, maybe an Inserter, may have provision to divert

bad packs for inspection.

15021 “Jam Out Of Xfer Cnvy Station 1"

HARDWARE: Original Xfer Conveyor

15021 “Jam Out Of Xfer Station 1"

HARDWARE: New Xfer Conveyor, Bridge and Two Stage

WHAT HAPPENED

Cycling, a pack did not leave Xfer Station 1 within a time.

ACTION TO TAKE

Check for a jam in the Xfer Station 1.

Test the sensor at Xfer Station 1.

Test the clutch and brake at the Xfer Station 1.

ANY OTHER ADJUSTMENTS

Adjust Engin Value#9 XcvyN OutOf Sta time.