Service manual

420T/438 - Barcode Data Specification 3 - 2D - Rev.3 ....113
Overview ...............................113
Bar Code Description ........................113
Bit Numbering per Character Conventions: ............113
Character String: ...........................113
GBR420 Setups for General Barcode Spec 3 -2D .........114
BarCode Character to Value to 5-Bit Value: ............117
To define the Extraction of Demand Feed: .............119
To define the Extraction of Inkmark: (method 1)..........119
To define the Extraction of Inkmark: (method 2)..........119
To define the Extraction of Insert Sta. 1 to 6: ...........119
Bit Number ..............................120
Bit Number .............................120
Barcode Setups ..........................120
Character Decimal Hex Binary (Bit Position 6-5-4-3-2-1) 121
GBR438/420T – Read End Of Set Operational Summary v2 . 122
Overview ...............................122
Common Demand Feed: .......................122
Lineread Demand Feed: .......................122
Barread Demand Feed: .......................123
D.1 CPU PC104 (SAT520) CARD .............125
D.1a Features ..........................125
D.1b General Description ...................125
D.2 I/O 96 Daughter CARD ................126
D.2a General Description ...................126
D.3 Single Channel Read Card ..............126
D.3a Function: .........................126
D.3b LED Indications: .....................127
D.6 Line Code Read Card .................128
D.6a Two Channel Switching Card ..............128
SECTION E. INTERFACE TO INSERTING EQUIPMENT . 129
E.1 ENCODER INSTALLATION ..............129
Below Used On: 775 Configuration W/O Host RPS Encoder ...129
Inserter Home Position Setup ....................129
This screen shows: .........................129
E.2 Removal of insterter's Hopper Side Plates .....130
E.2a REMOVE HOPPER GUIDE ................130
E.2b remove singulator finger ................130
E.2c 420T INTERFACE COUPLING ..............131
E.3 Transfer Conveyor Adjustments...........133
E.3a Package overhang at last station ............133
E.3b Position of the outfeed guides .............133
E.3c Fold quality ........................133
E.3d If a package spacing problem occurs .........133
E.3e Configuration of Exit sensor module ..........133
E.3f Testing of the exit sensor ................133
E.4 Setup of Demand switch ................134
F.1 Software Rev Update using E-Mail .........135
F.2 GBR OMR Reader Set-up...............135
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 TOC 7
071-33370-400
TABLE OF CONTENTS