Service manual

• Bit 1 = Station 2
• Bit 2 = Station 3
2 ‘0’ —’7’ ASCII numbers 0 to 7, 30 hex to 37 hex
• Bit 0 = Station 4
• Bit 1 = Station 5
• Bit 2 = Station 6
3 ‘0’ - ‘7’ ASCII numbers 0 to 7, 30 hex to 37 hex
• Bit 0 = Station 7
• Bit 1 = Station 8
• Bit 2 = Station 9
4 ‘0’ —’9’ ASCII numbers 0 to 9, 30 hex to 39 hex
• Package Page Count - Count 0 to 9 pages.(> 9, 3A hex, 3B hex etc.)
5 ‘0’ - ‘7’ ASCII numbers 0 to 7, 30 hex to 37 hex
• Bit 0 = End NA
• Bit1=--
• Bit2 = -
6 ‘0’ - ‘7’ ASCII numbers 0 to 7, 30 hex to 37 hex.
• Bit 0 = Postal Sort Mark, ink Mark, Kick Mark, Envelope Mark
• Bit 1 = Divert by Read Mark, Divert by Read Errors
• Bit 2 = Pack Valid, Good Pack
7 CR ASCII Carriage Return, OD hex
Response:
Character Data Description
.
1 ‘0’ ASCII number 0, 30 hex.
• Acknowledge from the Inserter that previous transmittal was accepted and
next transmittal can be made. Previous package has moved forward an
index position.
Notes:
• Package Page Count – Count 0 to 9 pages.(>9, 3A hex, 3B hex etc.)
• 10 pages = 3A hex =’:’, 11 pages = 3B hex =’;’, etc through the ASCII
chart.
• Acknowledge is required from the Inserter.
• Acknowledge response timeout is set by Engin. Value 36, default is 250
msec.
• Acknowledge response number of re-xmits is set by Engin. Value 37,
default is 1.
7) Zaandam I Protocol:
Character Data Description
1 ‘0’ — ‘7’ ASCII numbers 0 to 7, 30 hex to 37 hex.
• Bit 0 = Station 1 Bit 1 = Station 2 Bit 2 = Station 3
2 ‘0’ -’7’ ASCII numbers 0 to 7, 30 hex to 37 hex.
• Bit 0 = Station 4 Bit 1 = Station 5 Bit 2 = Station 6
3 ‘0’ - ‘7’ ASCII numbers 0 to 7, 30 hex to 37 hex.
• Bit 0 = Station 7 Bit 1 = Station 8 Bit 2 = Station 9
4 ‘0’ - ‘9’ ASCII numbers 0 to 9, 30 hex to 39 hex..
• Package Page Count - Count 0 to 9 pages.(> 9, 3A hex, 3B hex etc.)
5 ‘0’ - ‘7’ ASCII numbers 0 to 7, 30 hex to 37 hex.
• Bit 0 = End NA
INTRODUCTION
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 69
071-33370-400