Service manual

Weight Calculation
Postal Meter Selection Calculation. Done when pack is transferred to the
Inserter.
Package Weight = Envelope Weight + (No. Pages * Page Weight) + (Insert1
* Insert1 Weight)
+ (Insert2 * Insert2 Weight) + . . . through 8 inserts.
If Package Weight is greater than or equal(>=) to Meter 1 to 2 Weight Break
Value
• Then Meter 1 operates.
If Package Weight I less than(<) Meter 1 to 2 Weight Break Value and
greater than or equal(>=) to Meter 2 to 3 Weight Break Value
• Then Meter 2 operates.
If Package Weight less than(<) Meter 2 to 3 Weight Break Value (and less
than(<) Meter 1 to 2 Weight Break Value)
• Then Meter 3 operates.
Three Meter Example
Meter 1 to 2 Weight Break Value = 30
Meter 2 to 3 Weight Break Value = 20
Package Weight Meter 1 Meter 2 Meter 3
X
10 X
15 X
X
25 X
X
35 X
Three Meter Setup
Lineread Setup:
• Select Postal Meter Divert Enable “OFF”, to operate from Weights ONLY.
Inserter Setup:
• Postal Meter By Weight : Check ON to enable Postal Meters.
Inserter Setup 2:
• Postal Meter Divert(Postal Meter 1)
• 200. Meter “ON AT:’ in degrees.
• 10. Meter “OFF AT:’ in degrees.
• 6. Meter Position ‘STA:’ (6 stations after envelope insert station).
• 9. Enter Point Option ‘PT:’ (9 = Postal Meter Divert)
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 62
071-33370-400
INTRODUCTION