Service manual

Bar Read Setup 4
ReadFeed Type:
• Feed&Read – When it is desired to Feed first and then Read (normal)
• Read&Feed – When it is desired to Read before Feed (In cases where
the EOG (end of group) must be known before feeding next page).
Read&Feed:
• Start Delay – Only used with Read&Feed, and it is to delay the read to let
the previously fed document get clear of the feeder.
Cust ID Seq:
• Same ID – Code group matching between sets.
• Matching – Code group matching only within a set.
• Off – disables code group matching
Customer ID Code:
• Start – Customer number, group ID or other number can be found
beginning with this character in the Bar Code.
• Length – Number of lines after the start, i.e. start=6 length=3 (From the
gatemark the start is found at line 6 and the length is line 6, 7 and 8)
Code Lengths:
-1 disables reading in each category, 0 enables reading with variable length
and any number indicates length, e.g. Code 39 with a length of 6 = a code
block with 6 characters.
• Code 39 – 3 of 9 Bar Code
• I 2 of 5 – Interleaved 2 of 5 Bar Code
• Code 128
Number Reads:
• Num. Reads – the number of times the reader should scan and take
average to ensure good read. (poor printing can sometimes be a reason
for multiple reads)
INTRODUCTION
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 59
071-33370-400