Service manual

Bar Read Setup 2
The software permits a total of 30 characters in Bar Read, however,
physically that isn’t always practical due to the length of the code. For
instance, 3 of 9 code is physically larger than 128 code (not available on the
420T at this time). A code in excess of 15 characters becomes problematic
with a 3 of 9 code but a 128 code can easily exceed 20 characters.
Define the position in the barcode string to extract the information for the
following:
Group Seq Code:
• Start (0 to 30). Start character.
• Length (0 to 5). Number of characters.
• For individual bit management use the following.
• Start_Bit (0 to 30). Starting bit position within character.
• Length_Bit (0 to 30). Number of bits.
• IncType -
Page Seq Code:
• Start (0 to 30). Start character.
• Length (0 to 3). Number of characters.
• Start_Bit (0 to 30). Starting bit position within character.
• Length_Bit (0 to 30). Number of bits.
Inserts Code:
• Start (0 to 30). Start character.
• Length (0 to 20). Number of characters.
• Start_Bit (0 to 30). Starting bit position within character.
• Length_Bit (0 to 30). Number of bits.
Demand Feed Code
• Start (0 to 30). Start character.
• Length (0 to 20). Number of characters. Used with Normal-A or
Reverse-A, multiple character numeric values,
• Start_Bit (0 to 20). Starting bit position within character.
Ink Mark Code:
• Start (0 to 30). Start character.
• Length (0 to 20). Number of characters. Used with Normal-A or
Reverse-A, multiple character numeric values,
• Start_Bit (0 to 20). Starting bit position within character.
PmDivert Code:
• Start (0 to 30). Start character.
• Length (0 to 20). Number of characters. Used with Normal-A or
Reverse-A, multiple character numeric values,
• Start_Bit (0 to 20). Starting bit position within character
INTRODUCTION
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 57
071-33370-400