Service manual

A.8 LASER BAR CODE READ OPTION
A.8a Laser Safety
To prevent possible exposure to laser light that may exceed the CDRH’s
Accessible Emission Limit for a Class II laser, Your Model 30 has a
“Scanning Safeguard” feature, a Laser Shutoff Flip Panel. It shuts off the
laser power if the mirror wheel fails to rotate, which ensures that a stationary
laser beam cannot exit the scan head. This is a required feature, and it
should not be tampered with. Use only in case of an emergency.
The radiation level from the laser does not constitute a health hazard.
Exercise care to avoid any unnecessary, direct exposure to the eyes. Avoid
staring at the light source, since prolonged exposure could result in eye
damage. Avoid deliberate eye exposure to the beam. Inadvertent contact,
however, is not a cause for alarm.
Any service should be performed so as not to violate compliance with the
Code of Federal Regulations, Title 21. Part 1040, Section 10 (21 CFR
1040.10), as administered by the Center for Devices and Radiological
Health, a service of the Food and Drug Administration under the Department
of Health and Human Services. Do not attempt to defeat any safety
provisions.
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 52
071-33370-400
INTRODUCTION
Please Observe These Warning Labels