Service manual

EOG At Mark:
• Purpose - Controls the size of dynamic packages by indicating the end of
a group.
• Usage - A solid bar is placed in this location on the page with the largest
page ID number. All other pages within a group should have no mark in
this area.
Not EOG At Mark:
Ink Mark At:
PM Divt Mark: (Postal Meter Divert Mark)
Parity Mark (not available at this time)
• Purpose - Adds parity error checking to the code
• Usage - This location is used to maintain an even number of solid marks
within a code.
Note: The fields that are marked Optional can be eliminated by operator
configuration of the machine. However, when a data field is eliminated
package security and integrity suffers.
Sense Offset Mark:
Random At Mark:
Seq Stop At Mark:
Unseal At Mark:
Press “OK”
Line Read Setup 4 (TJ Read Sys - Obsolete)
(“Setup” > “Line Read” > “Setup 4”)
The TJ Read System has been discontinued and is no longer used.
The above screen is printed here for informational purposes only.
INTRODUCTION
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 51
071-33370-400