Service manual

The purpose of the Group Set mark is to ensure pages from two different
packages do not get processed in a single package. Group Set marks must
be present when using GROUP SEQUENCING.
PAGE SEQUENCE:
• PAGE UP - Choose if the page is counted UP (1, 2, 3, 4).
• PAGE DOWN - Choose if the page is counted DOWN (4, 3, 2, 1).
• ROLL UP - Cycle counts up sequentially to a selectable value set in “Line
Read Setup 3 (Group Seq and Page Seq - Min and Max)
• ROLL DOWN - Cycle counts down sequentially from a selectable value
set in “Line Read Setup 3 (Group Seq and Page Seq - Min and Max)
• ITEM COUNT - Choose when the first sheet in a package indicates the
total number of sheets in that package.
• Total UP -
• Total Down -
Parity Mark: - :
• Odd -
• Even -
• NONE- No page sequence.
There is a limit of three Page-Sequence marks. Their purpose is to give an
individual identity to each page within the package. The maximum number of
pages in a package is seven. Page-Sequence marks must be present when
using PAGE SEQUENCING.
Seq Shutdown:
• Clr Last -
• Stop Last -
• Clr First -
• Stop First -
• None -
Item Verify – :
• First Pg –
• Last Pg –
• Off –
Ink Mark:
PM Divert:
Unseal:
Subset Mark
The limit of sheets into the accumulator is seven. Subset is a special line in
the code that is used to indicate whether a set is more than seven pages.
When the package is more than seven pages the machine will use the
subset line to break the total page count into the amount of packages
necessary to complete the total count. This prevents possible damage to the
folder from packages greater than seven pages. The set and subset will go
out in different envelopes.
Random Mark :
Press “OK”
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 48
071-33370-400
INTRODUCTION