Service manual

A.7b 420T Line Read Setup Screens (GBR & BB+H)
Line Read Setup 1
(“Setup” > “Line Read” > “Setup 1”)
DEMAND FEED:
NORMAL - The machine will end the set on the presence of an End Of
Group mark. This means the only page in a set that has the mark is the last
one.
REVERSE - The machine will end the set on the absence of the End Of
Group mark. This means the all pages in the set will have the mark except
the last one.
YES/NO - Used where all pages have one mark. Each page will have an
End of Group or a NOT End Of Group mark.
FIRST PAGE – :
Used with Page Seq Down
EOG on first page of sel.
Page Seq Dn to 4, last page and End Of Group generated.
LAST ONLY - When this option is selected, the system looks not both and
not neither.
1
ST
ONLY – SetIt enable verify extact data.
• Uses IT enable verify comt to connt down to 1, End of Grp
TTL PG – (Total Page):
• Set It enable verify
• Set pg seq total up
• EOG at pg Seq = total
• Set pg seq total dn
• EOG at
Press “Cancel” to void any changes made to this screen or “Ok” to set the
changes and return to the “Line Read Setup 0” screen.
GROUP SEQUENCE:
• UP - Choose if the group is counted UPward. (1, 2, 3, 4). Sets must be in
order.
• DOWN - Choose if the group is counted DOWNward. (4, 3, 2, 1). Sets
must be in order.
• MATCHING - will match marks within a set. All marks in the set must be
the same. Sets may be in random order.
• SAME ID - :
• NONE - No group sequence.
INTRODUCTION
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 47
071-33370-400