Service manual

A.6n Engineering Values (Password Protected)
The above screen permits adjustment of the Engineering Values of program
control and machine parameters. Using this screen a vast number of
parameters can be changed to suit the specific needs of the machine and
job setup.
Enter by selecting “Engin Values” from the Setup Screen and enter “4444” to
jump to the screen on the right. Once inside this screen changes to program
defaults and modification to machine timing settings can be made. Please
record any previous settings before making any changes. In this way it will
be possible to return should the new change create a problem.
Number:
Value:
• For settings, refer to Section A.8 for the default Engineering Values List.
Reset to Default:
• Press this button to reset only the current Engineering Value displayed to
its default value. This value is changed on the display only. Pressing the
“OK” button saves the default value, “Cancel” exits and returns the
Engineering Value to the current value.
The screen displays 10 Engineering Values at one time.
• The highlighted Engineering Value Number can be moved up or down
one at a time (single up or down arrows). or 10 at a time (double down
arrows).
• The Engineering Value can be modified up or down one increment at a
Time (single up or down arrows) or a value can be directly keyed in with
the keypad.
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 44
071-33370-400
INTRODUCTION