Service manual

A.6l Inserter Setup 3
PM Divert, Postal Meter 2, and Postal Meter 3:
• NOTE ON POSTAL METER WEIGHING: The 420T can accommodate
up to three postal meters (PM Divert 2 and 3 are located in Inserter Setup
3). Based on the values entered in “Weight Breaks”, “Page Env Wts”, “Ins
1-6 Wts”, and “Ins 7-12 Wts” the document will be stamped by the
appropriate postal meter. The dollar value must be manually entered in
the postal meter.
• The value you enter in the Postal Meter Weights can be any unit of
measure as long as it is consistent. If one weight break is set to reflect
ounces, all other settings must reflect ounces, including the inserts and
the postal meter itself. Likewise, if one is set to reflect grams, they must
all be set to reflect grams. The numbers entered are relevant only to each
other.
Postal Meter 1 (PM Divert in Inserter Setup 2):
• Is normally set to On At 10. This will enable the postal meter at the
correct time. This value may need to be adjusted if the postal meter
doesn’t place the postage in the correct place. Postal Meter 2 (found in
Inserter Setup 3) should then be set to 40 higher than the new Postal
Meter 1 value and Postal Meter 3 should be 40 higher than Postal Meter
2.
Off At:
• Should be set to “10" for all three.
Station: 0:
• Is set to the value of the last chain section of the inserter after the
envelope stuffer and the turnover (04, 05, 06, 07, etc.). This is normally
set to “07" on a six station inserter.
Point :xx:
• Selects the postal meter output line to the 420T. This is normally set to
“0" for PM Divert, ”1" for Postal Meter 2, and “2” for Postal Meter 3.
Weight Breaks:
• The 420T will total the weights of all documents, inserts, and the
envelope and then send it to the correct postal meter. Because you are
setting the weight breaks as well as the envelope, page, and insert
weights, it is important to keep the unit of weight (i.e., oz) consistent.
• 1 / 2 Enter the Weight Break of Postal Meter 1 to Postal Meter 2.
• 2 / 3 Enter the Weight Break of Postal Meter 2 to Postal Meter 3.
Page Env Wts:
Page:
• Enter the weight of the individual page; the 420T will sum the weight of all
pages automatically.
Env:
• Enter the weight of an individual envelope.
• Ins 1-6 Wts and Ins 7-12 Wts
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 42
071-33370-400
INTRODUCTION