Service manual

Example of “Inserter Station Swapping” set-up on the

GBR

• Example: If you want a decode for insert feeder 4 to pull from insert feeder

1 set 1 = 4

• If you want a decode for insert feeder 1 to pull from insert feeder 4 set 4 =

Demand Degree:

• This is similar to setting dwell time on an engine. As the speed of the

machine is increased, home may be programmed at a position prior to 0

degrees allowing for lag time in components at higher speeds.

• Degrees may be set for 0 thru 12,000 cycles per hour in 2,000

increments.

• Note: Inserter degrees are reset to zero at the occurrence of a home

pulse for either inserter encoder.

Check to see if the example at the left is needed now that the above screen

is present.

420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 40

071-33370-400

INTRODUCTION