Service manual

Bad Pack Stop:
• This box is defaulted “on” or “checked.” The machine will stop on a bad
pack and enable the bad pack indicator light on the inserter. If unchecked
or “off”, the machine will not stop on a bad pack.
Subset:
• Select the “Subset By Count” function in either Barcode or Linecode by
entering a subset page count then selecting “Remove” in the Inserter
Setup, Subset function.
None:
• Subset pause is not used
Pause:
• Inserter will not advance until the transfer conveyor feeds a second pack
into an open feed station
Remove:
• Inserter will not advance and permits the operator to remove the packs
deposited in the open feed station on the inserter.
Station Setup:
• Note: Insert Station positions are referenced from the station at which the
documents are inserted into the envelope (“Insert Sta: 0"). Insert Station
1 would be the station upstream from Insert Station 0. Insert Station -1 is
the Insert Station downstream from Insert Station 0.
• When set to “0” the station is always off.
When set to 1 more than the total number of stations the station will always
be on.
• If a station is down, one of the other stations can be programmed to take
its place.
• Station Setup 1-9
• Station Setup 10-18
INTRODUCTION
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 39
071-33370-400