Service manual

• Enables viewing the version of line code reader software. Also verifies
communication with read board if a version is returned.
OMR Sensors
• Enables viewing the action of the sensor signals in the monitor window
for diagnostic purposes.
A.6h Bar Read Setup
Note: Refer to Section A.9d for setup information.
A.6i Inserter Setup 0
Inserter Protocol
• Select either “Inserter” or “InserterP”
The following I/O points have dual usage depending on Protocol selected
and interface PCB used (002D-08138 or 002D-07599).
Refer to I/O Rack #1 (Opto Rack “B” – Section B Electronics)
Inserter InserterP
(U.S. Application) (Typical European Application)
1-04 = Separation Sol #7 Inserter P Data Bit #1
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 36
071-33370-400
INTRODUCTION