Service manual

Off Delay – Time:
• This timer value is the period of time after the 420T has been stopped (by
pressing the Start/Stop key) that the system waits for the printer to finish
sending paper. The feeder has stopped but the 810, IF-42, and creeper
keep running and collecting paper. (Upon the 420T stopping, a FULL
signal (W-1:18) was sent to the printer).
A.6g Line Read Setup 0
Note:
• Refer to Section E.1a & b for an explanation of GBR Line Code Read.
• For a complete setup of Line Code Reading and setup screens 1 to 4 see
Section E.1c
Line Read Type:
OMR:
• default, used with GBR Systems F40 Line Code Readers
GBR OMR:
• Not used on 420T V6
GBR Code 8:
• not used on 420T V6
GBR Code 16:
• not used on 420T V6
Job Number
• System will save all the parameters for up to 10 line code jobs. To
program, select a job number, set all settings for the job in Line Read
Setup 1, 2, and 3 screens. Pressing the OK button in each setup screen
saves those parameters to the job number selected.
Reset Job
• Press this button to reset the job parameters to defaults for the job
selected.
Line Calibration
Important Note: Used only for B+H Line Read, not GBR Line Read
• This function will calibrate the line code reader for proper location of
marks for interpretation of code. Before pressing “Line Calib” make sure
Reader Type “Line” in System Setup screen is selected. “Read” must be
selected in Feeder Setup and all sensors must be properly adjusted. All
Line Read Setup screens must be setup. Select Calibration “On” in Line
Read Setup 2 before starting and “Off” when finished.
Get Version
INTRODUCTION
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 35
071-33370-400