Service manual

A.6e Xfer Cvyr (Transfer Conveyor) Setup
Exit Device Type:
• XferCvyr-1(default) or Coll-1
Xfer CvyrN:
• Off to select old style Transport Conveyor (no independent staging) or On
to select independent staging devices. Set XCvyrN Type for staging
locations.
XCvyrN Type:
• 1 selects all three stations (optional Folder Exit Station and both stations
in 2 Stage Conveyor).
• 2 selects only the two stations in the Two Stage Conveyor. The optional
Folder Exit Station will be bypassed.
• 3 selects only the final station of the Two Stage Conveyor
• 4 Bypass Bridge plus 2-Stage Conveyor
• 5 Folder Exit Station and Collector
Collect Subsets:
• Off (default) or On. Off = no subsets.
Subset Data Xfer (Used with serial communication only)
• Last Pack – the data is transferred when set is complete
• All Pks – the data is transferred on each subset
INTRODUCTION
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 33
071-33370-400