Service manual

stops feeding, purges the accumulator and transfer conveyor to the inserter,
then powers down automatically.
Sheet Length:
• Double Arrow Up” button increments to standard sheet sizes: A6, 8.5”,
11”, 14”, A4, and A5
• “Single Arrow” buttons adjust sheet length in tenths of an inch (range = 63
to 154)
Package Size:
• Input up to 14 which is the maximum pages allowed in the accumulator. 1
to 14, Default = 1
• For Read, 1 greater than maximum expected (5 for the Line Code test
set); or number of fixed pages with no Read.
Reader Type:
• Line, Bar, or None (Off)
Exit Conveyor Type:
• Xcvyr – Select this option if using any one of several options of document
transfer to inserter. Then select the required type of transfer desired by
going to Xfer Cvyr screen to choose.
• Hopper Fill - Select “Hopper Fill” when the inserter will be taking the
folded documents from an insert station hopper either with or without a
demand signal. See Eng. Value 20. With no Inserter
• Conveyor – with or without demand. See Eng. Value 20. With no
Transfer Conveyor (Xfer Cvyr). Exit at Folder with Folder Exit Sensor.
Inserter Connect:
• Inserter Online. By demand. See “Inserter Setup 1” screen for Open
or Gripper setup.
• Inserter Offline. Selecting this allows the inserter to run independent of
the 420T without
Batch Processing:
• Batch Sheet
• Select job size by entering the number of sheets to run. When selected,
the “Batch Off” button changes to “Set Sheets.” When “Sheet” is selected
and a batch size entered, the machine will complete the package
containing the last sheet.
Batch Package:
• Select job size by entering the number of packages to run. When
selected, the “Batch Off” button changes to “Set Packs.”
Batch Off:
• Disables Batch Processing.
“Batch Off” Button:
• Changes to “Set Packs” or “Set Sheets” depending on the option
selected. Press to enter batch value—a numeric keyboard is
displayed—then press “=” to set. Batch value is displayed to the left of
the button. This button is not available when Batch Processing “Off” is
selected.
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION A – PAGE 30
071-33370-400
INTRODUCTION