Service manual

• 4. Jog the inserter slowly through one cycle, observing mount closely.
You will notice that as the mount swings downward it will bottom against
the shaft behind it. If it does not, swing mount further down and cycle the
inserter again.
E.2c 420T INTERFACE COUPLING
The machine is designed to permit the operator to connect the 420T directly
to the inserting device. The output is conveyed to the inserting device by an
articulated conveyor arm. The arm places the document directly in position
for the inserter’s gripper arm to pull the document out of the conveying arm
and place it directly onto the track of the inserter.
Orientation: As viewed from operator area (front) of the inserter.
• 1. Gain access to shafts located under cover to the right of station 1, at
table height.
• 2. Jog inserter so gripper arms are moving towards insert stations: stop
when vertical.
INTERFACE TO INSERTING EQUIPMENT
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION E – PAGE 131
071-33370-400
Singulator Finger
Gripper Arms Orientation to 420T