Service manual

1 8 9 0 9
for this example.
Define Insert Start = 1
Define Insert Length = 5 Must use the entire
number.
Demand Feed Data Extracted = “18909” “18909” is converted to a
number for the math.
Define Insert Bit Start = 10
Define Insert Bit Length = 6
Binary weight ‘512’ present? Yes = Insert Sta. 1 ON
Binary weight ‘1024’ present? No = Insert Sta. 2 OFF
Binary weight ‘2048’ present? Yes = Insert Sta. 3 ON
Binary weight ‘4096’ present? No = Insert Sta. 4 OFF
Binary weight ‘8192’ present? No = Insert Sta. 5 OFF
Binary weight ‘16384’ present? Yes = Insert Sta. 6 ON
Bit Number
Bit Number allows for pre-decoding the barcode string.
Bit Number
5 For Code 39 decoded(see table below) to 5-Bit values. Bit
Positions 5-4-3-2-1.
6(NT) No decoding. 6-Bit values. Bit Positions 6-5-4-3-2-1.
7(NT) No decoding. 7-Bit values. Bit Positions 7-6-5-4-3-2-1.
8(NT) No decoding. 8-Bit values. Bit Positions 8-6-5-4-3-2-1.
Barcode Setups
A listing of Barcode extraction setup sections.
Group Seq Code
Start (0 to 30). Start character.
Length (0 to 5). Number of characters.
Start_Bit (0 to 30). (1 to 30)Starting bit position within character.
Length_Bit (0 to 30). Number of bits.
Page Seq Code
Start (0 to 30). Start character.
Length (0 to 3). Number of characters.
Start_Bit (0 to 30). (1 to 30)Starting bit position within character.
Length_Bit (0 to 30). Number of bits.
Inserts Code
Start (0 to 30). Start character.
Length (0 to 20). Number of characters.
Start_Bit (0 to 30). (1 to 30)Starting bit position within character.
Length_Bit (0 to 30). Number of bits.
Demand Feed Code
Start (0 to 30). Start character.
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION C – PAGE 120
071-33370-400
PROBLEM ANALYSIS