Service manual

ANY OTHER ADJUSTMENTS
This pack was marked bad.
Was there an Xfer Conveyor error in the previous cycle?
Remove and inspect this pack and other suspect packs or allow the pack
to be diverted for inspection downstream.
Set Engin. Value#55 to 1 to set all packs in the Xfer Conveyor bad.
The following device, maybe an Inserter, may have provision to divert
bad packs for inspection.
15058 “Data Overwrite Sta 2 - Set Sta 2 Pack Bad”
HARDWARE: New Xfer Conveyor, Type 4, Flats to Two Stage
WHAT HAPPENED
Cycling, a pack reached Xfer Station 2, but the data from the previous
pack associated with Xfer Station 2 is still present.
ACTION TO TAKE
Did the previous pack move to Xfer Station 2 normally, no error?
Or did the previous pack exit the Xfer Conveyor normally to the following
device?
Test the sensors at Station 2.
ANY OTHER ADJUSTMENTS
This pack was marked bad.
Was there an Xfer Conveyor error in the previous cycle?
Remove and inspect this pack and other suspect packs or allow the pack
to be diverted for inspection downstream.
Set Engin. Value#55 to 1 to set all packs in the Xfer Conveyor bad.
The following device, maybe an Inserter, may have provision to divert
bad packs for inspection.
15059 “Data Overwrite Sta 1 - Set Sta 1 Pack Bad”
HARDWARE: New Xfer Conveyor, Bridge and Two Stage
WHAT HAPPENED
Cycling, a pack reached Xfer Station 1, but the data from the previous
pack associated with Xfer Station 1 is still present.
ACTION TO TAKE
Did the previous pack move to Xfer Station 2 normally, no error?
Or did the previous pack exit the Xfer Conveyor normally to the following
device?
Test the sensors at Station 1.
ANY OTHER ADJUSTMENTS
This pack was marked bad.
Was there an Xfer Conveyor error in the previous cycle?
Remove and inspect this pack and other suspect packs or allow the pack
to be diverted for inspection downstream.
Set Engin. Value#55 to 1 to set all packs in the Xfer Conveyor bad.
The following device, maybe an Inserter, may have provision to divert
bad packs for inspection.
420T V6LT OPERATOR & SERVICE MANUAL ISSUE 2009/06 Rev. 6/21/2011 SECTION C – PAGE 102
071-33370-400
PROBLEM ANALYSIS