Specifications
Table Of Contents
- Home
- Table of Contents
- 1 General Information 1-1
- 2 EBC-BX Technical Reference 2-1
- 2.1 Introduction 2-1
- 2.2 Intel FW82443BX / SMSC Victory-66 Chipset 2-1
- 2.3 Memory Installation 2-1
- 2.4 Interrupt Routing 2-2
- 2.5 Power/Reset Connections 2-3
- 2.6 Mouse Interface 2-3
- 2.7 Real Time Clock/Calendar 2-4
- 2.8 Keyboard Interface 2-4
- 2.9 Serial Interface 2-5
- 2.10 Parallel Printer Port 2-12
- 2.11 Speaker/Sound Interface 2-12
- 2.12 PC/104 Bus Interface 2-12
- 2.13 PC/104 Plus Bus Interface 2-13
- 2.14 Floppy Disk Interface 2-14
- 2.15 IDE Hard Disk Interface 2-15
- 2.16 Watchdog Timer Configuration 2-16
- 2.17 Status LED 2-16
- 2.18 Battery Select Control 2-16
- 2.19 DiskOnChip Configuration 2-17
- 2.20 Parallel I/O 2-18
- 2.21 VGA Configuration 2-21
- 2.22 Ethernet Controller 2-23
- 2.23 Fan Power Connector 2-24
- 2.24 Multi I/O Connector 2-25
- 2.25 USB Connector 2-25
- 2.26 Jumper Connector Summary 2-26
- 3 AWARD BIOS Configuration 3-1
- 3.1 General Information 3-1
- 3.2 Entering Setup 3-1
- 3.3 Setup Main Menu 3-1
- 3.4 Standard CMOS Features 3-2
- 3.5 Advanced BIOS Features Setup 3-6
- 3.6 Chipset Features Setup 3-11
- 3.7 Integrated Peripherals Setup 3-14
- 3.8 Power Management Setup 3-19
- 3.9 PNP/PCI Configuration 3-23
- 3.10 PC Health Status 3-25
- 3.11 Frequency/Voltage Control 3-25
- 3.12 Load BIOS Defaults 3-26
- 3.13 Set Supervisor Password 3-27
- 3.14 Set User Password 3-27
- 3.15 Save and Exit Setup 3-27
- 3.16 Exit without Saving 3-27
- 4 EBC-BX DiskOnChip Configuration 4-1
- 5 WS16C48 Programming Reference 5-1
- APPENDIX A I/O Port Map
- APPENDIX B Interrupt Map
- APPENDIX C EBC-BX Parts Placement Guide
- APPENDIX D EBC-BX Parts List
- APPENDIX E EBC-BX Mechanical Drawing
- APPENDIX F WS16C48 I/O Routines and Sample Program Listings
- Warranty and Repair Information
2.5 Power/Re set Con nec tions
Power is ap plied to the EBC- BX via the con nec tor at J3 (Mo lex part number 26-60-7091). The pin
defi ni tions for J3 are given be low. An op tional push- button- reset (Nor mally Open) may also be routed
into J3 if de sired. Mo men tary clo sure to ground forces a hard ware re set.
Note : The 3.3 Volt i nput pin does not pro vide power to any de vices on the board. It is routed di -
rectly to the PC/104Plus Bus and is only re quired if there are PC/104Plus cards that re quire 3.3 Volts be
sup plied from the Bus. The +12 and -12 Volt pins are routed di rectly to the PC/104 con nec tors and flat-
panel con nec tors and are not re quired for nor mal board op era tion.
2.6 Mouse In ter face
A PS/2 mouse may be at tached via the con nec tor at J1. An adapter ca ble, CBL- 225-1 is avail able
from Win Sys tems to adapt to a con ven tional PS/2 mouse con nec tor. The pin out for J1 is shown here.
030923 OPERATIONS MANUAL EBC-BX Page 2 - 3
WinSystems - "The Embedded Systems Authority"
o 1
o 2
o 3
o 4
o 5
o 6
o 7
o 8
o 9
+5V
GND
GND
+12V
+3.3V
GND
+5V
-12V
PB Reset
J3
1 o
2 o
3 o
4 o
MSDAT
N/C
GND
+5V
MSCLK
J1