Assembly

ManualsBrandsWinston Porter ManualsLightingCallie 1 - Light Dimmable Half Moon

Mounting strap

w/ ground screw

Threaded rod

1ea 3/4"X4" 2ea 3/8"*H45mm

Wire connnector Hex nut Deco nut

(round nut)

3ea P3 Orange 2ea @3/8X3mm 1ea 3/8"*H9mm

Finial Sping washer Bottom cap

1ea Ø13*H9mm 1ea Ø15*H3mm 1ea 38*H28mm

Part Needed Quantity

Reason why

( missing, scratched, broken glass, bent, bad finish)

Comments

PARTS & ASSEMBLY SHEET

Notice:

Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

below to be filled out by retailer

For Customer Service, contact the place of purchase to arrange for replacement parts.

NOTE: I

NSTALL THE GLASS ASSEMBLY AFTER

THE FIXTURE IS HUNG.

1. Attach the finial (N) to Threaded rod (L) and slide through

Bottom Cap (K)

2. Place the Glass Shade (M) flush with the Back plate (J) just

under the "L" shaped lip.

3. Slide Bottom cap assembly (K+L+N) into hole at the bottom

of Glass shade (M), with the threaded rod going through the

hole in bottom of fixture back plate and tighten with Hex nut

(O).

*If the glass does not sit flush with the wall remove the glass,

gently press the lip up bit to increase glass tension and

reinstall the glass.

4. Install the light bulb in accordance with the fixture's

specifications.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!) 

Fig. 1

Junction box screws

2ea #8-32N*18mm

Read and review installation instruction sheet before

assembling the fixture.

IXTURE

SSEMBLY

NSTRUCTIONS

Summary of content (2 pages)

PAGE 1
PARTS & ASSEMBLY SHEET Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
INSTALLATION INSTRUCTIONS For Wall Mount Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig. 1) 1. Carefully remove the new fixture from the carton and the yellow bag that holes all your parts. Check that all parts are included as shown in the illustration and parts list. Fig. 1 JUNCTION BOX C B A I 2. Shut off power at the circuit breaker and remove the old fixture from wall, including the old mounting strap. 3.