Assembly Instructions: Chair

CHAIR PART LIST

C. CHAIR BACK 4 PCS

D. SEAT FRAME 4 PCS

E. FRONT LEG 8 PCS

F. CUSHION 4 PCS

PAGE 1
CHAIR PART LIST F C D E C. CHAIR BACK 4 PCS D. SEAT FRAME 4 PCS E. FRONT LEG 8 PCS F.
PAGE 2
CHAIR ASSEMBLY INSTRUCTIONS DIAGRAM #3 REQUIRED HARDWARE IN THIS STEP E NO. DESCRIPTION SKETCH QTY 1. FLAT WASHER 4 PCS 2. SPRING WASHER 4 PCS 3. NUT 4 PCS 4. OPEN WRENCH 1 PC PLASTIC PLUG E E 1 2 4 3 D 1. Attach 2 front legs (E) to seat frame (D) using 4 nuts (3), 4 spring washers (2), and 4 flat washers (1) as shown. Note: The seat frame (D) has 2 holes on each side,which are used to attach the seat. These holes are wider on the bottom and narrower on the top.
PAGE 3
CHAIR ASSEMBLY INSTRUCTIONS DIAGRAM #5 REQUIRED HARDWARE IN THIS STEP NO. E E 7 7 7 7. DESCRIPTION SKETCH WOOD SCREW QTY 6 PCS 7 7 7 D F C 4. Place cushion seat (F) upside down on a non-abrasive table surface. The rear ( tapered end ) of the cushion seat (F) should be near the table edge. Hint: Protect the non-abrasive table surface and cushion seat (F) by laying a towel in-between the chair seat and table. 5. Place the assembled chair frame on the cushion seat (F) as shown.