Assembly Instruction

Step 6
Place the Barstool right side up on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the Barstool some 30cm to 50cm height from the ground.
Keep your feet and toes well away from the drop zone.
Drop the Barstool freely and vertically with all four legs, hitting the ground at the same time.
This Drop Test will help to ensure that all the Bolts and gaps reach full alignment status.
If wobble
Test again
30cm-
50cm
This Drop Test will help to ensure that all the Bolts and gaps reach full alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles are found, proceed to tighten all the Bolts.
When tightening these bolts, tighten sequentially.
Do not tighten any Bolt fully and then move towards the next one.
This could cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute the same drop tests.
If the Barstool is not stable it could lead to damage to the product.
Step 7
Inspect the Barstool and make sure all parts are connected.
Your Barstool is ready for use.
This Barstool can only be used on a flat, level surface.
Page 6 of 7