Service manual

7. Place new O-ring over vent tube and slide back against vent assembly.
CAUTION: Prior to applying final torque to screws in Step 8, verify solenoid wires are not
pinched between nut plate and vent assembly. This could create a shorted
circuit causing potential equipment damage and/or personal injury.
8. Place vent block on vent tube, line up nut plate behind vent assembly and replace the four
(4) screws securing block to vent tube and vent assembly.
9. Drop vent ball (if applicable) down through waffle onto vent block.
10. Insert weight into weight lifter.
11. Place vent back onto vent assembly.
12. Place muffler on fryer and place unit back into service.
REPLACE LATCH BLOCK (FRONT) (ITEM NO. 8)
Tools: Phillips Screwdriver #2; Box End Wrench - 9/16”; Silicone Sealant; Hammer; Putty
Knife.
Procedure:
1. DANGER: Turn off electrical power and disconnect electrical power supply. If unit is
hardwired CIRCUIT BREAKER MUST BE OFF.
2. Remove lid assembly and save for reuse.
3. Remove the two (2) screws securing eyebrow to relay panel and save for reuse.
4. Remove the four (4) screws securing escutcheon to relay panel and save for reuse.
CAUTION: Utilize care in preventing escutcheon from falling forward when removing
these screws. Lower escutcheon slowly until secure in open position.
5. Remove the four (4) screws securing
relay panel to side panels and save for
reuse. CAUTION: Utilize care in
preventing relay panel from falling
forward when removing these screws.
Lower panel slowly until secure
(See Figure 36).
FIG. 36
WINSTON
58
LIT.6710/REV.0/9-91