Service manual

Tools:
Open End Wrench - 1/2" (Qty - 2)
Procedure:
1. DANGER: Turn off electrical power, disconnect electrical power supply, drain shortening
and allow to cool. If unit is hardwired, CIRCUIT BREAKER MUST BE OFF.
2.
Remove lid from fryer.
3. Pad floor with cardboard and lay fryer over on side.
in
Tools:
Phillips Screwdriver #2.
Procedure:
1. DANGER: Turn off electrical power, disconnect electrical power supply. If unit
is hardwired, CIRCUIT BREAKER MUST BE OFF.
2.
Place lid in down position.
3. Remove the four(4) screws securing danger label panel to rear of fryer and save for reuse.
Tools:
Slotted Screwdriver - 1/4”; Phillips Screwdriver #2; Needle Nose Pliers.
Procedure:
1. DANGER: Turn off electrical power, disconnect electrical power supply. If unit is
back into service.
REPLACE VENT ASSEMBLY (ITEM NO. 44)
REPLACE WHEEL (ITEM NO. 25)
REPLACE DANGER LABEL PANEL (ITEM NO. 7)
8. Replace the four (4) screws securing escutcheon to relay panel.
9. Replace the two (2) screws securing eyebrow to relay panel and place unit back into
service.
4. Replace the four (4) screws securing new danger label panel to rear of fryer and place unit
4. Remove nut and bolt securing wheel to bracket and save for reuse.
5. Replace nut and bolt securing new wheel to bracket.
6. Return fryer to upright position, replace lid and place unit back into service.
WINSTON
38
LIT.6710/REV.0/9-91