Programming instructions
Collectramatic
®
Fryers – Very Low Pressure/Temperature – LP46, LP56
29
www.winstonind.com
800-234-5286
TROUBLESHOOTING
TROUBLE FAULT CODE
ALL FRYERS
Power lamp fails to light ................................................................ 1, [CS]
Power lamp dim............................................................................. 1, [CS]
Heat ON lamp not on when heating .............................................. [CS]
Display reads “Lo” or “Heat”, heat on lamp is off, and fryer ......... 18
is not heating up
No heat (all lamps out) .................................................................. 1, [CS]
Heats slowly .................................................................................. [CS]
Cooking oil smoking excessively ................................................... 2, 3, [CS]
Cooking oil foaming excessively ................................................... 3
Cooking oil boils over .................................................................... 4, 5, 6, 7
Cooking oil has burnt or bad taste ................................................ 8, 9, [CS]
Cooking oil breaking down too quickly .......................................... 8, 9, 10 [CS]
Cooking oil leak around collector gasket ..................................... 11, 12
Controls not responding correctly ................................................. [CS], 17
Hi Limit light is lit ........................................................................... [CS], 17
PRESSURE FRYERS ONLY
No pressure ................................................................................... 13, 14, [CS]
Low pressure ................................................................................. 14, 15, 16, [CS]
Pressure loss excessive through vent........................................... 13, [CS]
Pressure loss excessive through lid valve .................................... 15, 16
Cooking oil leaking from back of fryer .......................................... [CS]
[CS] Call for service (see page 31)
FAULT CODE CORRECTION
1. Open power line (check circuit breaker) ......................... Adjust or [CS]
2. Cooking oil level below top heater .................................. Adjust, See page 15
3. Cooking oil badly broken down ....................................... Clean or Replace
See pages 25-27
4. Cracklings left in or allowed to overfill ............................ Clean,
See pages 25-27
5. Never stir in collector after warm-up ............................... See page 16
6. Heat plate left out of collector ......................................... Replace
7. Improper warm-up (solid cooking oil in collector) ............... Adjust, see page 16
8. Cracklings allowed to reach bottom heaters ................... Clean,
See pages 25-27
9. Heater holder slipped - heaters touching........................ Adjust or [CS]
10. Fryer not kept clean ........................................................ Clean,
See page 25-27
11. Pot groove for collector gasket dirty ............................... Clean,
See pages 25-27
Continued on next page










