Programming instructions

xxxxxxxx
Collectramatic
®
Fryers – Very Low Pressure/Temperature – LP46, LP56
16
www.winstonind.com
800-234-5286
WARM-UP
Failure to follow procedure below may result
in first batch of cooked food being off-color
and improperly done.
DANGER: Do not turn on power unless all heater
coils are completely covered by cooking oil. Fill
shortening to a level between the Maximum and
Minimum oil level lines found on the inside of the
cookpot (see Figure 5).
1. Turn on circuit breaker and Power Switch.
2. Set Controls to start warm-up process by
pressing the channel button which contains
the desired programmed times and
temperatures (see Programming pages
13-14.
3. If STIR Signal comes on, IGNORE IT - DO
NOT STIR FRYER. IF FRYER IS STIRRED
AT THIS TIME, AQUALERT SYSTEM MAY
BE ACTIVATED* - After temperature reaches
250˚F (121˚C) display shows cooking oil
temperature. Wait for the fryer to continue to
warm up until the load message is displayed
*NOTE: See Aqualert in the Troubleshooting
section for a complete explanation.
4. Deep stir (into collector) cooking oil
vigorously for at least 15 seconds.
5. Load message will change to cooking oil
temperature. DO NOT stir cooking oil.
6. Load message will be displayed.
7. Deep stir (into collector) cooking oil
vigorously for at least 15 seconds.
8. Load message will change to cooking oil
temperature. DO NOT stir cooking oil.
9. Load message will be displayed.
FIGURE 4
Cone:
Do not stir
below this
area after
the first
round of
cooking
each day.
1
st
Stir
2
nd
Stir