User's Manual

connection. When connected, it will stay on in BLUE.

• Discoverable Mode:

SPK-90A will stay discoverable and is searchable by other Bluetooth compatible devices

passively. The LED light will be flashing in RED before connection. When connected, it will

stay on in BLUE.

• Connected Mode:

SPK-90A is connected with a Bluetooth Compatible Device and is read to stream music. The

LED light stays on in BLUE under this mode.

• Idle Mode;

SPK-90A is not discoverable but still can be connected to the devices which are paired before.

As it is not discoverable, the connection initialization is triggered from the Bluetooth

Compatible Device. The LED light will be flashing in RED under this mode.

D. Pairing

• Press and Hold the Bluetooth Button for 3 seconds, then release when 2 beep tones are heard

with the LED light flashing. SPK-90A enters into Discoverable Mode

• Turn on the Bluetooth feature on your mobile compatible device. Search for SPK-90A. Pair and

connect to SPK-90A. If prompted for passcode, enter 0000. If pairing is successful, the LED

light will stay on in BLUE.

NOTE: Above are general steps to pair to a Bluetooth device, for more specific instructions on

Bluetooth connectivity for your device, please consult your Bluetooth Compatible Device’s

manual.

E. Volume:

• To turn up the volume, press the Volume Up Button

• To turn down the volume, press the Volume Down Button

NOTE: Volume can also be adjusted on your Bluetooth Compatible Device, consult your

Bluetooth Compatible Device’s manual for instructions.

F. Reconnection

• Reconnection is available to the last connected or previously connected device.

 Press the Bluetooth Button once it is turned on.

 Initiate a connection from your Bluetooth Compatible device when the speaker is not

connected to any device.

G. Switching between Paired Devices

• Switch between your current connected device to your previous connected device by pressing

the Bluetooth Button once.

NOTE: Ensure that your next paired device’s Bluetooth feature is ON and is ready to accept

connections.