User Manual

JDY-25M Super BLE Bluetooth Module

Method 2: Key Learning

1.Enter Learner mode: Double-click the PWRC pin, and the STAT light will flash slowly, and the LED light of the

ALED pin will be off to indicate that it has entered the Learner. In the learning state, if the OUTPUT pin does not

learn the key value, it will flash once a second. When the code sent by the Code sender is received, it will be

always on, indicating that the key value has been learned. When the KEY1-KEY5 pin of Learner is not pressed in

the learning state, it means that the learned key value of Learner OUTPUT1 to OUTPUT5 corresponds to the

KEY1 to KEY5 of Code sender, that is to say, Learner OUTPUT1 can only be controlled by the KEY1 of Code

sender, and of course, it also supports free learning.

Free learning method:

Example 1: The binding method of OUTPUT1 of Learner to KEY5 of Code sender:

Double-click the PWRC pin of Learner to enter the learn mode, and then press the KEY1 pin of

Learner to enter the learning state of Learner OUTPUT1, so that Learner OUTPUT1 can freely learn the key

values of Code sender KEY1 to KEY5. Press Code sender KEY5, and Learner OUTPUT1 will learn the KEY5

value of Code sender, so that Code sender KEy5 will be able to control the OUTPUT1 pin level of Learner.

2. Enter Code sender mode: Click PWRC pin, and the LED light of STAT pin off, and the LED light of ALED pin

flashes slowly, indicating that it has entered Code sender. Then press KEY1-KEY5, and Learner will learn the

key value sent by Code sender.

Quit Learner mode: Double-click the PWRC pin, and the ALED light will flash quickly (once a second).

Only after quitting the learn mode can the learned parameters work normally.

3. Quit Code sender mode: Click the PWRC pin, and the ALED pin flashes quickly( once a second). The

KEY1-KEY5 will take effect only after quitting the Code sender mode.

In particular, the mode can be distinguished by LED flashing:

Learner: The LED light of the STAT pin flashes slowly, and the LED light of the LEED pin is off, indicating that

it enters the Learner mode. In the Learner mode, the

OUTPUT

pin flashes, indicating that the pin is in the

learning state, and if it light constantly means the code has been learned.

Code sender: The LED light of

STAT

pin is off, and the

ALED

pin flashes slowly, indicating that it has entered

the Code sender mode. In the Code sender mode, press the

INPUT

button, and the corresponding

OUTPUT

will be high level.

Normal work：LED of ALED pin flashes quickly(once a second), if there is a central machine, the

STAT pin is on constantly, indicating normal work.

Key learning is generally used in the case of no APP or serial port configuration. If there is APP or

serial port configuration, it is easier to use.