User Manual

JDY-25M Super BLE Bluetooth Module
33
switch panel learns the value sent by SW1 of A switch panel, and LED2 of B switch panel will be
on, which indicates that LED2 has learned successfully. Second, press SW5 of B switch panel, at
this time, LED5 of B switch panel flashes, which indicates that LED5 learning begins. Then press
SW1 of switch panel A, LED5 of switch panel will be on, which indicates that learning has been
successful.
Step 3: A switch panel quit code sender mode, click PWRC pin, and LED of ALED pin flashes
(once in 1 second), indicating that the code sender mode has quit and normal working mode has
been entered.
Step 4: B switch panel quit learner mode, double-click PWRC pin, and LED of ALED pin flashes
(once in 1 second), indicating that the learner mode has quit and normal working mode has been
entered.
Step 5: At this time, SW1 of A switch panel can control the level of LED2 and LED5 of B switch
panel.
Clear learning code, press PWRC pin for more than 6 seconds, and all learning codes will be
cleared automatically.
The above is the configuration of the switch panel by learning mode. If using APP or serial port to
configure, it will be very simple to use.
If the user configures the above functions through the serial port, only several instructions are
needed.
A switch panel address is 0008, B switch panel address is 0009
1、AT+LEARN1
2、AT+SUBTYPE1
3、AT+LEAVAL2,1,0008
4、AT+LEAVAL5,1,0008
10.8 Application wiring diagram of one key binding and connect to the strongest signal slave