User Manual

JDY-25M Super BLE Bluetooth Module
19
AT+MINOR<Param> OK Param:（0000-FFFF）
Default：0007
AT+MINOR +MINOR=<Param>
If Minor value is 10180，AT instruction is: AT+MINOR27C4 27C4 is 10180 hex data
35、Set/query - iBeacon IBSING
Instruction Response Parameter
AT+IBSING<Param> OK Param:（00-FF）
Default：40
AT+IBSING +IBSING =<Param>
This parameter is applied to the check value of iBeacon signal at 1 meter.
36、Serial port status output enable set/query
Instruction Response Parameter
AT+ENLOG<Param> +OK Param：1 or 0
1：Open serial port status
output
0：Close serial port status
output
Default：1
AT+ENLOG +ENLOG=<Param>
37、Data instruction sent by multi-connected slave
Instruction Response Parameter
AT+DATA<Param1><Param2
>
+OK Param1：Indicates the master ID number,
values (1 to 4)
Param2：Indicates the data sent
+DATA=<Param>
In the
multi-connected
status, when JDY-25M is connected by more than one master, data can be sent to the
specified master through this instruction.
Example: Such as sending AABBCCDDEEFF data to master 1
AT+DATA1AABBCCDDEEFF
38、Set/query - Output IO level of current module
Instruction Response Parameter
AT+CUIO<PA>,<PB>, +OK PA：Output IO number (1 to 5)