User's Manual

13
Maintenance:
CLEANING INSTRUCTIONS: When cleaning, make sure you have unplugged the lighting
fi ture and allow to it cool to room temperature. Do not open the retaining clips when
cleaning. The lighting fi ture can be cleaned with a feather duster or a soft damp cloth.
You should plug in the lighting fi ture after it has been completely dried.
Troubleshooting:
Malfunction Cause Remedy
The light is
not working
The light is under calibration
Wait for 30 seconds until calibration is
finishe
Wrong light control setting selected Adjust setting
Main switch is OFF Switch on the Main switch
The light is
always ON
Continuous movement
in the detection zone
Check Switch 1 & 2 settings
The light is ON
without any
identifiable m vement
Movement occurred, but not identified y the
sensor (movement behind wall, movement of a
small object in immediate lamp vicinity, etc.)
Check Switch 1 & 2 settings
The light is not ON
despite movement
Rapid movements are being suppressed
to minimize malfunctioning of light or the
detection zone you have set is too small
Check Switch 1 & 2 settings
Other accessories:
The lighting fi ture is provided with a plastic cap and a cable bushing. Always refer to a
qualified ele trician if re-wiring of power cable is required. After re-wiring, plastic cap
is used for covering the original opening for power cable, and the cable bushing is used
for output of power cable / hardwire.