Specifications

FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
The CAMWIFI is designed to comply with the FCC statement. FCC ID is WUI-BT532767. The
host system using CAMWIFI Module, should have label indicated it contain modular’s FCC ID：
WUI-BT532767 . This radio module must not installed to colocate and operating simultaneously
with other radios in host system additional testing and equipment authorization may be required to
operating simultaneously with other radio.
The CAMWIFI is deaigned for a compact PCB design .It should be installed and operated with
Dash Cam or other minimum distance of 20 centimeters between the radiator and your body." To
comply with FCC regulations limiting both maximum RF output power and human exposure to RF
radiation, the maximum antenna gain including cable loss in a mobile-only exposure condition
must not exceed 0dBi in the 2.4G band. The CAMWIFI and its antenna must not be co-located or
operating in conjunction with any other transmitter or antenna within a host device.
The OEM can use metal antennas or FPC antennas, and the antenna gain is less than 0dBi for this
module.
If difference antenna types or host are used, C2PC should be applied.
Notice to OEM integrator
The end user manual shall include all required regulatory information/warning as show in this
manual. The OEM integrator is responsible for testing their end-product for any additional
compliance requirements required with this module installed.
The device must be professionally installed
The intended use is generally not for the general public.lt is generally for industry/commercial use.
The connector is within the transmitter enclosure and can only be accessed by disassembly of the