User's Manual

RFID Reader
Region setting includes
China1 area (840.625MHz~844.375MHz),
China2 area (920.625MHz~924.375MHz),
Europe area (865.7MHz~867.5 MHz),
USA area (902MHz~928MHz),
Korea and Japan area.
Choose the frequency band at your area, and then click ‘set’, ‘get’ is to check the
current band you have chosen.
Choose "save", the setting will be kept after power off.
7. Frequency hopping setting
Frequency hopping setting is in basic settings as below picture.
Picture 9 Frequency hopping setting
Click ‘get’, you will see the each hopping points of the frequencies.
Fixed frequency setting: fill in the frequency at the blank then click ‘add’, then click
‘set’, if successful, it will notice. Click ‘get’ can check out the set value.
Self-defining frequency hopping setting: input one frequency point, click ‘add’; then
input another, click ’add’. Repeat till you add all frequency points, then click ‘set’.
You can click ‘get’ to check if setting successfully.
8. Version info
Version information is displayed in basic settings as below picture.
Picture 10 Version information
Click ‘get’, you will get the version information, including Software version,
Hardware version, Firmware version and Module ID.
9. Temperature info
Temperature info is displayed in basic settings as below picture.